Connecting The Sawdust Extractor; Checking Blade Guard Functionality; Use; Switching On And Off - Parkside PTSS 1200 C2 Originalbetriebsanleitung

Connecting the sawdust extractor

♦ If required, attach the chip ejector adapter for
dust extraction to the chip ejector
♦ Connect an approved dust and chip extraction
device.

Checking blade guard functionality

NOTE
► Position the base plate for this operation on
the edge of a stable surface so that the saw
blade can be lowered.
♦ Activate the safety lock-out
circular saw.
♦ Check whether the saw blade
the blade guard and whether it moves back to
its starting position automatically.

Use

Switching on and off
Switching on
♦ Push the safety lock-out
in position.
♦ Press the ON/OFF switch
running, you can release the safety lock-out
Switching off
♦ Release the ON/OFF switch

Setting the cutting depth

♦ Undo the screw for the cutting depth adjust-
ment and push the stop to the desired
cutting depth on the cutting depth scale
–
without guide rail, see mark A.
–
with guide rail, see mark B.
♦ Retighten the screw for the cutting depth
adjustment .
NOTE
► Adjust the cutting depth to the thickness of the
workpiece. The blade should not extend more
than one full tooth depth under the workpiece.
PTSS 1200 C2
.
and lower the
rubs against
upwards and hold it
. Once the saw is
.
.
:
Setting the cutting angle
(mitre angle)
♦ Undo the two adjustment wheels for the cutting
angle .
♦ Tilt the motor to the desired cutting angle.
♦ Retighten the adjustment wheels
NOTE
► If you have set the cutting angle adjustment to
0° or 45°, you can use the fine adjustment
screws and
8a
ment that you require.

Note the cut line

♦ Cut line markings
9a
into the base plate
♦ Align the appliance to the corresponding 0° or
45° cut line markings
the set cutting angle.
♦ The inclined surfaces are reference points for this.

Connecting the guide rails

The guide rails will help you to make straight
cuts.
♦ To connect the 2 guide rails, push the
connector into the groove of the guide rails.
Tighten the grub screws
hex key.
.
to make any fine adjust-
of 0°/45° are imprinted
.
in accordance with
9a
9a
using the supplied
GB │ MT │
51 ■