Making Settings; Changing The Saw Blade - Parkside PMB 1100 A1 Originalbetriebsanleitung

Mounting the band saw on the swivel arm
If you plan to operate the appliance using the saw
table , proceed as follows:
♦ Attach the swivel arm
screws supplied in the corresponding holes
of the appliance housing (see fig. E on the fold-
out page).
♦ The band saw is automatically fixed in the up-
permost position. To release the position, pull
out the locking pin
at the same time.
WARNING!
► Make sure at all times that the power cord
can not get near the saw blade.
► If you want to use the unit with the saw table,
attach the power cord with the two cable
A
holders , as shown in the following picture:

Making settings

Adjusting the handle
♦ To adjust the handle
on the handle.
♦ Turn the handle
♦ Retighten the wing screw
Using the vice
♦ Turn the handle on the vice
clamp the workpiece.
♦ Turn the handle on the vice
unclamp the workpiece.
│ GB │ IE
■ 18
using the 3 long wing
and lower the band saw
A
, loosen the wing screw
to the required position.
.
clockwise to
anticlockwise to
NOTE
► You can also flip the quick release
in order to adjust the vice
quickly. Fold the quick release
again to fix the vice
the vice handle
Setting the cutting angle (mitre angle)
♦ Undo the cutting angle adjustment
it anticlockwise.
♦ Set the required cutting angle using the angle
provided.
♦ Retighten the cutting angle adjustment
turning it clockwise.
Adjusting the workpiece stop
■ During normal operation, the workpiece stop
must be fixed in the lowest position.
♦ If the workpiece stop
sawing, you can use the two workpiece stop
screws to remove it. Use the supplied small
hex key to do this. In this way, you can
adjust the workpiece stop
workpiece stop
workpiece stop screws

Changing the saw blade

WARNING! RISK OF INJURY!
► Wear protective gloves to avoid injury.
♦ Release the saw blade clamping lever
turning it anticlockwise
♦ Remove the two locking screws
Phillips screwdriver (not supplied).
♦ Remove the two protective covers
♦ Carefully remove the saw blade
the guide rollers
page).
♦ Remove any sawdust with a brush or compressed
air.
♦ Slide the saw blade
with the saw teeth pointing upwards. Make sure
that the guide rollers
saw blade .
upwards
15a
setting more
back down
15a
in place. After this, use
to make fine adjustments.
by turning
is a hindrance when
upwards. Fix the
in place again using the two
.
.
with a
.
. Start at
(see fig. B on the fold-out
into the guide rollers
completely grip the
PMB 1100 A1
by
by