Operation - Cameo TS 200 FC Bedienungsanleitung

7 CONTROL KEYS
MENU – access the options menu for system settings by pressing MENU. Pressing it again will return you to the main screen.
ENTER – lets you change a value and confirm changes to values.
UP and DOWN – select the individual menu items in the options menu and in the submenu (mode, system information, etc.). Changes
a value, for example, the DMX address.
Press MENU and ENTER at the same time to access the last edited menu item.
ZOOM
8
Knurled knob for adjusting the size of the light beam
(adjusted fully to the right= minimum light beam size, adjusted fully to the left = maximum light beam size).
9 SAFETY EYEBOLT
Safety eyebolt for securing the spotlight on crossbeam installations.

OPERATION

NOTE:
As soon as the spotlight is correctly connected to the power, various pieces of information will appear on the display during startup: "Update
Wait..." (only for servicing purposes), "WELCOME TO Cameo", the model number, and the software version. The spotlight is ready after this
process, and the mode that was previously selected will activate.
MAIN SCREEN DMX MODE
The upper row on the display shows "DMX Addr" and the bottom line shows the currently set DMX start address. As soon as the
DMX signal is interrupted, the display begins to flash. Once the DMX signal is restored, it stops flashing. If there is no input within
approx. 30 seconds, the main screen is automatically activated.
MAIN SCREEN STAND-ALONE MODE
The bottom row on the display shows the currently active stand-alone mode (Slave, Auto, Macro, HSI, CCT, Direct). If there is no input within
approx. 30 seconds, the main screen is automatically activated.
6
9
8