Technical Specifications - Cameo TS 200 FC Bedienungsanleitung

The Adam Hall 3 STAR, 4 STAR, and 5 STAR product ranges include an extensive selection of suitable cables.
DMX CABLES
When fabricating your own cables, always observe the illustrations on this page. Never connect the shielding of the cable to the ground
contact of the plug, and always make certain that the shielding does not come into contact with the housing of the XLR plug. If the shielding
is connected to the ground, this can lead to short-circuiting and system malfunctions.
Pin Assignment
DMX cable with 3-pin XLR connectors:
Shield
1
3
2
DMX TERMINATORS (TERMINATING RESISTORS)
To prevent system errors, the last device in a DMX chain needs to be equipped with a terminating resistor (120 ohm, 1/4 Watt).
3-pin XLR connector with a terminating resistor: K3DMXT3
5-pin XLR connector with a terminating resistor: K3DMXT5
Pin Assignment
3-pin XLR connector:
1
3
2
DMX ADAPTER
The combination of DMX devices with 3-pin connectors and DMX devices with 5-pin connectors in a DMX chain is possible with suitable
adapters.
Pin Assignment
DMX Adapter 5-pin XLR male to 3-pin XLR female: K3DGF0020
Pins 4 and 5 are not used.
Pin Assignment
DMX Adapter 3-pin XLR male to 5-pin XLR female: K3DHM0020
Pins 4 and 5 are not used.

TECHNICAL SPECIFICATIONS

Model number:
Product type:
Type:
Color spectrum:
CRI (CCT Modus)
Number of LEDs:
LED type:
LED PWM frequency:
Beam angle (half peak angle)
DMX input:
DMX output:
DMX color functions:
DMX functions:
12
1
3
2
CLTS200FC
LED Spotlight
Fresnel theater spot with zoom function
RBGALC
> 90
1
200 W
650 Hz, 1530 Hz, 3600 Hz, 12 kHz, 25 kHz (configurable)
13 ° – 49 °
3-pin and 5-pin XLR, male
3-pin and 5-pin XLR, female
Direct, HSI, CCT
Dimmer, fine dimmer, stroboscope, red, green, blue, amber, lime, cyan, color macros, CCT,
tint, hue, saturation, device setting
DMX cable with 5-pin XLR connectors (pin 4 and 5 are not used):
5
4
4
3 3
2
2
1
Shield
5-pin XLR connector:
5
4
3
2
1
5
1