Device Information - Cameo TS 200 FC Bedienungsanleitung

DimResp = Dimmer response
PWM = LED PWM frequency
FacReset = Reset to factory settings
Calibrate = Individual color calibration

DEVICE INFORMATION

You can access the options menu by pressing MENU. Using the UP and DOWN buttons, now select the "Sys Info" menu item and confirm via
ENTER. This will take you to the submenu for displaying the device information. Use the UP and DOWN buttons again to select the desired
submenu item and then access the information by pressing ENTER (see table). Press MENU again to return to the main screen. If there is no
input within approx. 30 seconds, the main screen is automatically activated.
Sys Info
Temp = Displays temperature of LED unit
Op. Hours = Operating time display
Firmware = Displays the device software version
10
LED The LED spotlight responds abruptly to
changes in the DMX value
Halogen The spotlight behaves like a halogen
spotlight with soft changes in brightness
650 Hz Sets the LED PWM frequency
1530 Hz
3600 Hz
12 kHz
25 kHz
No Do not reset (confirm via ENTER)
Yes Implement reset (confirm via ENTER)
R, G, B, A, L, C Multimode calibration of red, green, blue,
amber, lime, and cyan colors with values
from 000 to 255
Temp LED xxx °C / xxx °F
Temp C°/F° °C (= displays in degrees Celsius)
°F (= displays in degrees Fahrenheit)
Op. hours x:xx h Displays the total operating time in hours
and minutes
Firmware V1.xx