• Press the lever (10) and lift the pusher (3).
• Remove the product from the table (4).
3
• Clean the slicer as described in the relevant section.
The slicer SHOULD be cleaned thoroughly at least once a day and more frequently
where necessary.
Clean the slicer before use if it has been out of service for some time.
WARNING:
Cutting hazard! Use protective cut- and tear-resistant gloves and
perform all operations with extreme care.
PAY ATTENTION AT ALL TIMES!
• Remove the receiving tray (18).
F300 VO
18
Fig. 20
10
SLICER CLEANING
Fig. 21
3
4
18
IT
EN
10
F300 VO L
29