Inhaltsverzeichnis
Werbung
The appliance is supplied with a cable conform to the power stated on the technical plate, and it is only
necessary to connect a standard plug.
If direct connection is required, place between the appliance and the mains, a switch dimensioned to the
corresponding load in accordance with existing norms.
The earth green/yellow cable must not be discontinued.
Before connecting the appliance verify that:
A) The relief valve and the plant can stand the load of the appliance (see technical data plate)
B) The feeding plant is outfit with an efficient earth socket according to existing standards
C) The socket or the switch used for the connection are easily reachable with the appliance installed
The manufacturer declines every responsibility if the above accident preventions are not
respected.
A) To switch on the contact grill
Turn the knob the main switch (Fig.1-A) to Pos. 1 and the temperature thermostat (Fig.1-C) to the desired
temperature.
B) Before using the grill
The grease residuals could produce smoke and unpleasant smells. It is therefore advisable to heat up the
plate for about 15 min. at the temperature of 300°C before using the same for the first time.
The appliance has two pilot lamps:
- green lamp: power on (Fig.1-B)
- yellow lamp: heaters on (Fig.1-D)
- to switch off the appliance set the main switch (Fig.1-A) back to Pos. 0
Before cleaning and maintenance operations, the appliance must be disconnected and cold.
The stainless steel parts must be treated with non abrasive detergents.
The control panel and the knobs should be wiped with a soft humid cloth.
The cast iron cooking surfaces have to be cleaned exclusively through the stainless steel spatula
supplied with the machine and/or by a dry abrasive sponge
Never wash the appliance with a jet of water as it might cause infiltrations in the electrical
components.
The control of the electrical components should be carried out by qualified personnel.
2) INSTRUCTIONS FOR USE
3) CLEANING AND MAINTENANCE
Werbung
Inhaltsverzeichnis
