Cabling Your Dell/Emc Fibre Channel Storage - Dell PowerVault MD3000i Bedienungsanleitung

Table 2-1. Fibre Channel Hardware Interconnections (continued)
Cluster Component Connections
Dell/EMC Fibre
Channel storage
system
Dell/EMC Fibre
Channel switch
Gigabit Ethernet
switch

Cabling Your Dell/EMC Fibre Channel Storage

You can configure your Oracle
area network (SAN) attached configuration, depending on your needs.
See the following procedures for both configurations.
Figure 2-2 illustrates the hardware connections used in setting up a
SAN-attached Fibre Channel cluster.
• Two CAT 5e or CAT 6 cables connected to the LAN
• One to four fiber optic cable connections to each Fibre Channel
switch. For example, for a four-port configuration:
– One fiber optic cable from SPA port 0 to Fibre Channel
switch 0
– One fiber optic cable from SPA port 1 to Fibre Channel
switch 1
– One fiber optic cable from SPB port 0 to Fibre Channel
switch 1
• One fiber optic cable from SPB port 1 to Fibre Channel switch 0
• One to four fiber optic cable connections to the Dell/EMC Fibre
Channel storage system
• One fiber optic cable connection to each PowerEdge system HBA
• One CAT 5e or CAT 6 connection to the private Gigabit NIC on
each PowerEdge system
• One CAT 5e or CAT 6 connection to the remaining Gigabit
Ethernet switch
®
cluster storage system in a four-port storage
Fibre Channel Cluster Setup
13