Cable Compensation Unit Aw-Rc400; Introduction; Accessories - Panasonic AW-PH400E Bedienungsanleitung

Introduction

p The cable compensation unit (AW-RC400) is capable of
providing cable compensation for analogue composite,
analogue Y/C or analogue component signals in 5
channels up to 500 meters (when the BBC No.PSF1/2M,
BELDEN 8281 connecting cable or its equivalent is used).
p It features a 5 μs advance function for the sync signals in
order to provide easy support for a system (another cable
compensation unit is required) in which the coaxial cable
connected between this cable compensation unit
(AW-RC400) and the camera is longer than 500 meters.

Accessories

Rack-mounting adapters ............................................................ 2
Mounting screws (M4 V 8 mm) .................................................. 4

Cable Compensation Unit AW-RC400

Notes
p Input either sync signals to the sync signal input
connector on the cable compensation unit (AW-RC400)
or input video signals to one of the video channels
(input composite signals or Y signals with sync to video
input connector 1). If neither of these signals is input,
the monitor selection will not be controlled.
p The AW-RC400 provides cable compensation for the
three Y, Pr and Pb signal channels by means of a single
control. This means that the Y, Pr and Pb signals cannot
be adjusted separately. In the same way, the Y and C
signals cannot be adjusted separately.
p The AW-RC400 is a cable compensation unit and, as
such, it does not come with signal conversion functions
(for converting component signals into composite
signals, for instance).
p When the cable compensation unit is to be discarded at
the end of its service life, ask a specialized contractor
to dispose of it properly in order to protect the
environment.
46 (E)