Panasonic AW-PH400E Bedienungsanleitung Seite 25

Installation
(Be sure to ask your dealer to install the unit.)
w Attaching the wire
[Multi Purpose Camera (AK-HC1500G/AK-HC1800G)]
A drop-prevention wire is provided with the unit.
Follow the instructions below to use it to couple the camera to the pan-tilt head.
p When attaching the wire, be absolutely sure to use a Phillips-head screwdriver to tighten the 2 mounting screws
Notes
securely.
8.5 mm
p Tighten up the mounting screw at the
torque levels specified in the table on
the right, and then check that there is
no play.
Use the mounting screw for wire (M4 M 8 mm with flat washer and spring washer) to attach one end of the wire to the pan-tilt
head's arm.
Attach one end of the wire (use the 6.5 mm hole in the mounting fitting) to the top of the camera using the mounting screw
for wire (inch thread: 1/4-20UNC), flat washer and spring washer.
For a stand-alone installation
p Camera: AK-HC1500G/AK-HC1800G
Mounting screw for wire
(inch thread: 1/4-20UNC),
Drop-prevention
flat washer and spring
wire
washer
[provided with camera]
Mounting screw for wire
(M4 M 8 mm) with flat washer and spring
washer
[provided with pan-tilt head]
Drop-prevention wire (approx. 200 mm long)
4.2 mm
1.2 mm
Attaching the wire
Mounting screws (Inch thread)
Mounting screws (M4)
Arm
24 (E)
6.5 mm
4.2 mm
Hole
diameter
6.5 mm
4.2 mm
For installation on the ceiling
p Camera: AK-HC1500G/AK-HC1800G
Mounting screw for wire
(M4 M 8 mm) with flat washer
and spring washer
[provided with pan-tilt head]
Indoor Pan/Tilt Head AW-PH400
Mounting fitting
11 mm
Clamping torque
2.0 N m (20 kgf cm)
• •
1.5 N m (15 kgf cm)
• •
Mounting screw for wire
(inch thread: 1/4-20UNC), flat
washer and spring washer
[provided with camera]