Panasonic AW-PH400E Bedienungsanleitung Seite 12

Indoor Pan/Tilt Head AW-PH400
Parts and their function
Y connector [Y]
This is the output connector for the camera's video
signals.
It is connected to the Y/VIDEO connector on the cable
compensation unit (AW-RC400) or monitor, etc.
Use a BNC coaxial cable for the connecting cable.
1394 connector [1394]
This is used for the control of the convertible camera and
pan-tilt head equipped with an IEEE1394 card
(AW-PB310) or other card.
Use an IEEE1394 cable for the connecting cable.
! SDI connector [SDI]
This is the output connector for the camera's video
signals.
When the SDI card (AW-PB504) or other card is inserted
in the convertible camera for use, SDI signals can be
output.
Use a BNC coaxial cable for the connecting cable.
" G/L IN connector [G/L IN]
This is the genlock signal input connector.
It is connected to the G/L OUT connector on the cable
compensation unit (AW-RC400) or other unit.
Use a BNC coaxial cable for the connecting cable.
# PROMPTER IN connector [PROMPTER IN]
The video signals for the prompter are input to this
connector.
Use a BNC coaxial cable for the connecting cable.
$ Pb connector [Pb]
This is the output connector for the camera's video
signals.
It is connected to the Pb connector on the cable
compensation unit (AW-RC400) or monitor, etc.
Use a BNC coaxial cable for the connecting cable.
% Pr/C connector [Pr/C]
This is the output connector for the camera's video
signals.
It is connected to the Pr/C connector on the cable
compensation unit (AW-RC400) or monitor, etc.
Use a BNC coaxial cable for the connecting cable.
11 (E)