I Connection With A Time Lapse Vtr; I Cable-Loss Compensation Setting - Panasonic WV-CU161C/B Bedienungsanleitung

I Connection with a Time Lapse VTR

Alarm in/out and recover-reset in/out are connected between the time lapse VTR and the rear of the controller.
Note: Use a relay as shown below when connecting an indicator such as a buzzer that exceeds 16 V DC 100 mA.

I Cable-loss Compensation Setting

The maximum allowable cable length between a camera and a controller is 1 200 m {4 000 ft} when using an RG-6U or 5C-2V
or equivalent cable. Cable loss compensation can be adjusted in the setup menu as S, M or L.
<Example>
Camera
A m (A ft)
Time Lapse VTR
1 2 3 4 5
4 3 G 2 1
ALARM IN
NC NO
Relay
+12 V
Cable length (with RG-6U or 5C-2V)
Unit: m {ft}
WV-CU161C
500 {1 650} ≤ A <
900 {3 000} ≤ A < 1 200 {4 000} →
ALARM
1
IN
2 COM
ALARM
3
RESET IN
ALARM
4
RECOVER OUT
ALARM
5
OUT
1 ALARM IN
2 ALARM OUT
G GROUND
3 RECOVER IN
4 RESET OUT
NC: Normally Closed Contact
NO: Normally Open Contact
Alarm Indicator etc.
0 {0} ≤ A < 500 {1 650} →
900 {3 000} →
Cable compensation
parameter in WV-CU161C
Setup menu
S
M
L
13