Pan/Tilt Control Panel Aw-Rp400; Introduction; Accessories - Panasonic AW-PH400E Bedienungsanleitung

Introduction

p This pan/tilt control panel enables up to 5 indoor pan/tilt
heads (AW-PH400) to be controlled.
p By connecting the remote operation panel (AW-CB400) or
remote control box (WV-CB700A) to the control panel, the
convertible cameras mounted on the pan-tilt heads can be
controlled at the same time.
p By installing an additional control panel, 2 of the 5 units
in the pan-tilt head system can be controlled at the same
time.
p Up to ten tracing memories can be accommodated.
p Up to 50 preset memories can be set.
p The connection distance between the control panel and
pan-tilt head system can be extended up to a maximum of
500 meters.

Accessories

Zoom switch ................................................................................. 1
Plug (D-SUB 15-pin) for tally/INCOM system ...................... 1 set
Rack-mounting adapters ............................................................ 2
Mounting screws (M4 V 8 mm) .................................................. 4
Notes
p The AW-RP400 cannot be used to control the pan-tilt
heads (AW-PH300, AW-PH300A, AW-PH350,
AW-PH500, AW-PH600 or AW-PH650).
p Before using the control panel, the movement range
(limiters) of the pan-tilt head system must be set
without fail.
p When the AW-RP400 is to be discarded at the end of
its service life, ask a specialized contractor to dispose
of it properly in order to protect the environment.
30 (E)

Pan/Tilt Control Panel AW-RP400