Silvercrest SSRA1 Bedienungs- Und Sicherheitshinweise Seite 53

Problem
The robot vacuum cleaner
does not charge.
The robot vacuum cleaner
gets stuck during cleaning.
The robot vacuum cleaner
returns to the charging
dock to recharge be-
2
fore it is done cleaning.
The robot vacuum cleaner
does not clean according
to the cleaning schedule.
The remote control is not
working (the effective
range is 5 m).
Reason
The robot vacuum cleaner is not mak-
ing good contact with the charging
contacts on the charging dock
3
The charging dock is switched off
2
and the robot vacuum cleaner is
switched on, draining the battery.
The robot vacuum cleaner is ob-
structed by cables, curtains or rugs on
the floor.
Low battery, the robot vacuum cleaner
automatically returns to the dock to
recharge.
Wood floors, tiling and different floor
levels, cleaning speed and time of the
robot vacuum cleaner vary.
The robot vacuum cleaner is not
switched on.
Battery low
The robot vacuum cleaner is clogged.
Remote control batteries low.
The robot vacuum cleaner is switched
off / robot vacuum cleaner battery low.
The infrared sensor on the remote con-
trol or the receive on the robot vacuum
cleaner are dirty and unable to trans-
mit or receive signals.
An object near the robot vacuum cleaner
is interfering with the infrared rays.
Troubleshooting
Solution
Ensure there is good contact be-
tween the robot vacuum cleaner
. and the charging contacts
2
the charging dock
We recommend continuous
charging when the robot vacuum
cleaner is not in use to ensure it
has enough power for the next
cleaning.
The robot vacuum cleaner automat-
ically tries to find different solutions.
If it is unable to find a solution, you
will need to intervene.
Charge the robot vacuum
cleaner.
The cleaning times of the robot
vacuum cleaner vary based on
the complexity of the room, dirt
level and cleaning mode.
Switch on the power switch
(Position "–").
If the robot vacuum cleaner is on
Standby, ensure it is charged so
it will always have enough power
to clean.
Switch off the product and clean
the dust collector
parts.
Replace the batteries with new bat-
teries and install these properly.
Verify the power switch
switched on (Position "–") and
the robot vacuum cleaner has
enough battery power.
Clean the infrared sensor or the
receiver on the robot vacuum
cleaner with a cotton cloth.
Avoid using the remote control
near other infrared devices.
on
3
.
2
10
and other
18
is
10
GB/IE 53