Draining And Refilling; Keep Your Spa Clean - Jacuzzi j-300 serie Montageanweisung Und Bedienung Und Wartung

E. Lift unthreaded filters cartridges from skimmer well.
F. If present, first remove the dispenser for water sanitation, as in-
dicated above. Rinse impurities from the folds in the filters in each
cartridge with pressurized water. Start at top and work downward
to the handle. Repeat until all folds are clean.
G. Submerge both filter cartridges in spa. Tilt threaded end up-
ward to removed trapped air bubbles from each cartridge, then
keep both cartridges submerged.
H
(Filter Cover Back View)
H. Place each cartridge back into skimmer well, then rotate each car-
tridge handle clockwise to thread back into the fitting. Note the di-
rection of installation. Do not over tighten.
I. Install clean skimmer bag back onto clips as shown.
J. Tilt filter cover back then gently press down to latch against re-
taining clips.
L. Turn power to spa back on.
I
Periodically, both filter cartridges will need a more thorough
cleaning.
I
We suggest cleaning as shown (Point F). Soak the filter
overnight in a plastic container filled with a solution of water and a
specific cleaning product.
I
The cartridges last approximately two years with proper care, ro-
tation, and water quality maintenance. Replacement cartridges
may be purchased from your Jacuzzi Premium dealer.

Draining and refilling

About every 3 to 6 months, you will want to replace the water in
the spa. Frequency of water replacement depends on frequency
of use, care taken in maintaining water quality, etc.
You will know it is time for a change when you cannot control
suds and/or you can no longer see the normal sparkle to the wa-
ter, even though the key water balance measurements are all
within the proper parameters.
WARNING! Turn off power to spa before draining it. Do not
turn the power back on until your spa has been refilled.
J
I
If it is extremely cold, and the spa is outdoors, freezing could occur
in the pipes of the hydraulic system (see the section on "Winterizing").
To drain your spa, perform the following steps:
1. Turn off power to spa.
2. 2.
3. 3.
4. 4.
5. 5.
2. Locate the drain valve on the front lower plastic pan. Hold the
larger (rear) body to prevent it from turning, then loosen and re-
move the cap.
3. Connect a garden hose.
4. Rotate the rear valve body 1/3 turn counter clockwise to un-
lock the drain valve.
5. Pull the larger (rear) body outward to open drain.
6. After the spa drains, perform steps 2-4 in reverse order to close
the drain prior to refilling the spa.
7. After refilling,turn on power to the spa and follow the steps list-
ed under "Start-up instructions"
N.B.: Always fill your spa through both filter fittings.

Keep your spa clean

To preserve the sheen of your spa's surface, it is crucial that you
avoid using abrasive cleaners or cleaners which have adverse ef-
fects on the surface.
Regardless of the cleanser used, use extreme care to assure that no
soap residue is left on the surface. This could cause suds when the
spa is refilled.
Pillow Care
C
B
A
Remove and clean the headrest pillows as needed with soapy
water using a cloth or soft-bristle brush.
31