Stereo Receiver (Optional) - Jacuzzi j-300 serie Montageanweisung Und Bedienung Und Wartung

Stereo receiver (optional)

BLUEWAVE™ Spa Stereo System
To start enjoying your new stereo receiver, please read the following
operation instructions in their entirety.
1
1. Media Locker Handle
Slide the handle to lock and unlock the protective door.
2. Power Button
Press power button once to turn on stereo system. Press a sec-
ond time to place the stereo in "Standby" mode and the red light
will remain illuminated.
3. Auxiliary Input Jack Connector
Allows you to connect an auxiliary device by using a 3.5 mm ca-
ble.
4. Universal Serial Bus (USB) Device Connector
Allows you to connect your device via a USB port and a USB ca-
ble compatible with your device.
5. Auxiliary Device Holding Base
The removable base securely holds the Auxiliary device, such as
an iPod/MP3/iPhone, in place. It can be removed for larger de-
vices.
6. 3.5 mm Cable (puchased separately)
Use this cable to connect your Auxiliary or MP3 device to the
stereo via the "AUX" connection.
7. Apple 30-pin to USB Cable (puchased separately)
Use this cable to connect your compatible iPod, iPhone or MP3
device to the stereo via the "USB" connection.
2
USB
AUX
3 4
5
6
7
CAUTION: RISK OF ELECTRICAL SHOCK OR EQUIPMENT
DAMAGE! Never install, remove or operate any electrical de-
vice (e.g. Apple Device/MP3/USB/AUX/Bluetooth) while
hands are wet or while sitting partially or fully immersed in
the spa!
CAUTION: Never leave electrical devices in the Media Locker
when spa is not is use to prevent damage from outdoor elements!
Never spray Media Locker with a pressurized water hose for any
reason! Damage to the device or spa stereo system caused by wa-
ter intrusion is not covered under the manufacturer's warranty!
Damage to Media Locker port or electrical devices due to ex-
cessive force or improper alignment during installation or re-
moval from Media Locker is not covered under warranty.
Pairing the Remote and Stereo
In order for the remote to operate the stereo, you need to pair
them using the following method:
- Make sure the stereo unit is in "Standby" mode. LED power light
will be red.
- Press any button on the remote to turn it ON. The remote LCD
display will read "No Link."
- Press and hold the "Mode" button on the remote. At the same
time, press and hold the power button on the stereo for 2 sec-
onds.
- The remote LCD display will read "Welcome," "Load" and "Radio"
if the pairing sequence was successful.
Audio Settings
The Audio button, provides access to many of the stereo's set-
tings. By continually pressing the Audio button you can scroll
and adjust the following functions: BAS-TRE-BALFAD-DSP-AREA-
LOUD-DX-STEREO (respectively).
Note: You can adjust the settings by pressing the Audio button,
making your adjustments and pressing the Audio button to go the
next feature. If you exit the setting menus continually press the Au-
dio button until you reach the setting you would like to adjust.
Bass Setting
Press the Audio button once to access the bass setting. The LCD
display will change to "BAS 0,". Press the Up button to adjust the
setting to a maximum of +7. Press the Down button to adjust
the setting down to -7.
Note: The default setting is "0." This feature is disabled when a "Dig-
ital Sound Processor" (DSP) setting is active such as "Rock," "Classi-
cal," or "Pop."
35
AUDIO
MODE
1 2 3