Initial Operation; Connection Without Adapter; Connection With Adapter; Operation - Parkside PRRS 15 A2 Originalbetriebsanleitung

GB IE NI
• To avoid damage and personal injury,
only use the unit on leak-tight pipes and
drains that are resistant to pressure.
• Do not leave equipment unattended in
the workplace.
• Switch on the pressure washer only
when the pipe cleaning hose is at least
up to the red marking in the pipe to be
cleaned.
During high pressure operation, do not
pull the inserted hose completely out of
the pipe to be cleaned. You might be
injured by the four pressure jets coming
out at the back.
• The maximum washing temperature
must not exceed 60 °C. The hose could
be damaged.

Initial Operation

Connection without adapter

Connecting:
1. Connect the connecting piece (2)
to the pressure washer jet gun
PARKSIDE (8).
2. Turn it by 90° until it engages
(bayonet joint).
Disconnecting:
3. Release the connection piece (2)
by pressing and turning through
90° in the opposite direction
(bayonet locking device.

Connection with adapter

Connecting:
1. Attach the adapter (9) to the
connection piece (2) and turn
it through 90° until it locks into
place (bayonet locking device).
6
2. Connect the jetz gun (8) (bayo-
net locking device) and screw
the retainer nut (10) of the
adapter (9) to the spray gun.
Disconnecting:
3. Release the rettainer nut (10) on
the adapter (9).
4. Release the locking devices by
pressing and turning through
90° in the opposite direction
(bayonet locking device).

Operation

1. Push the pipe cleaning hose
(4) at least up to the red safety
marking (5) into the pipe to be
cleaned.
Caution! The red safety marking
must be in the pipe before the
pressure washer is switched on.
The high-pressure jet could cause
injury.
2. Switch on the pressure washer
and squeeze the trigger on the
spray gun (
3. Whilst the nozzle head (3) is mo-
ving through the pipe indepen-
dently, feed in the pipe cleaning
hose (4) manually.
4. To release blockages, squeeze
the trigger several times in a row
then release it.
5. Your progress in the pipe can be
marked with the marking ring
(6). The progress can be read
from the white scale (
the hose, which is spaced at in-
tervals of 1 m.
8).
7) on