10�4 User Settings (Optional); 10�4�1 Configuration Of The Standard Display; 10�4�2 Set The Standard Unit Of Measurement For Flow; 10�4�3 Select The Medium - autosen AS005 Bedienungsanleitung

10.4 User settings (optional)
10.4.1 Configuration of the standard display
► Select [SELd] and determine the standard unit of measurement:
- FLOW = the current flow in the standard measuring unit is displayed�
- TEMP = the current medium temperature in °C is displayed.
► Select [diS] and set the update rate and orientation of the display:
- d1, d2, d3: update of the measured values every 50, 200, 600 ms�
- rd1, rd2, rd3: display as for d1, d2, d3; rotated by 180°.
- OFF = the measured value display is deactivated in the Run mode�
The LEDs remain active even if the display is deactivated� Error
messages are displayed even if the display is deactivated�
10.4.2 Set the standard unit of measurement for flow
► Select [uni] and set the unit of measurement:
l/min, m3/h, m/s
[uni] is only available if the operating mode GAS or LIQU is selected�
For the operating mode REL the flow value is always displayed in %
of the measuring range�
10.4.3 Select the medium
► Select [MEdI] and define the medium to be monitored:
H2O, OIL1*, OIL2**, GLYC, AIR�
Depending on the operating mode different media are available (→
4�2)�
*OIL1 = high-viscosity oil (≥ 40 mm²/s at 40 °C / ≥ 40 cSt at 104 °F)
**OIL2 = low-viscosity oil (≤ 40 mm²/s at 40 °C / ≤ 40 cSt at 104 °F)
10.4.4 Configure colour change display
► Select [coLr] and define the colour of the process value display:
rEd, GrEn, r1ou, r2ou, G1ou, G2ou (→ 4.9).
10.4.5 Setting the output logic
► Select [P-n] and set PnP or nPn�
74
Menu DIS:
[SELd]
[diS]
Menu CFG:
[uni]
Menu INI:
[MEdI]
Menu DIS:
[coLr]
Menu CFG:
[P-n]