Temperature Monitoring; 4�8 Measured Value Damping (Dap) - autosen AS005 Bedienungsanleitung

Flow measurement
1
FOU=On
130 %
120 %
3
4
FrP
5
=100 %
FOU=OFF
0 %
MAW
UL
Err
Figure 2: Output curve frequency output
MAW: Initial value of the measuring range for non-scaled measuring range
MEW: Final value of the measuring range for non-scaled measuring range
FSP: Frequency start point with scaled measuring range (only temperature)
FEP: Frequency end point with scaled measuring range
FrP: Frequency signal for upper measured value
OL: Above the display range
Err: The unit is in the error state
Frequency signal (FrP at factory setting = 100 Hz)
1
Measured value (flow or temperature in % MEW)
2
Display range
3
Measuring range
4
Scaled measuring range
5
4.8 Measured value damping (dAP)
The damping time enables setting how many seconds after the output signal has
reached 63 % of the final value if the flow value changes suddenly� The set dam-
ping time stabilises the outputs, the display and the process value transfer via the
IO-Link interface. The signals [UL] and [OL] (→ 13 Troubleshooting) are defined
under consideration of the damping time�
52

Temperature monitoring

FOU=On
=100 %
2
FOU=OFF
FEP MEW
OL Err
100 % 120 %
1
130 %
3
120 %
4
FrP
5
0 %
MAW FSP
UL
Err
2
FEP MEW
OL Err
100 % 120 %