(9)
(6)
(5)
(5)
(2)
(5)
(3)
IMPORTANT! When installing the new PC
board, ensure that the heat transfer paste
on the modules (9) is not scratched or re-
moved.
Position the new PC board on the heat
3
sink
NOTE! To avoid creating mechan-
ical stresses, the screws should
first be tightened to 0.5 Nm then
subsequently to 2.0 Nm.
Screw the module onto the heat sink
4
with 4 x 4x9 mm TX20 screws (6).
Tightening torque = 0.5 Nm
Tighten the 4x 4x9 mm TX20 screws
5
(6) to 2.0 Nm.
Fix the PrimoPS PC board with 14 x
6
4x9 mm TX20 screws (5)
Tightening torque = 2 Nm.
Reattach all cables (2)–(4) to the Pri-
7
moPS.
(5)
(4) (5)
141