Fronius Primo serie Serviceanleitung, Ersatzteilliste Seite 119

b)
(2) (2) (3)
Installation
IMPORTANT! A good seal is achieved only
by adhering to the following procedures a)–
b) which ensure the sealing foam is correc-
tly positioned.
a) Suspend the power module cover on
2
the mounting pins above, pull the pow-
er module cover downwards in a more
inclined position a) and swing it under
tension onto the base shell b).
IMPORTANT! When closing the cover,
make sure that the springs on the keys en-
gage in the guides.
Then fasten the power module cover
3
(3) with 4 x 5x18 mm TX25 screws (2)
with a sealing washer
(2)(2)
Tightening torque = 2.5 Nm
NOTE! If the screw threads slip
and will no longer grip, use the fol-
lowing screws:
PT 5x25 mm T25 KT25
(Item number 42,0401,4231)
Mount the inverter on the wall bracket
4
at a maximum angle of 11° and press it
down towards the wall bracket
119