Lighting Control - Carrier WTC-RCI-D Installationsanweisungen

To set the lights
Press the Menu button
■
until the Lights screen appears.
Press the Up button
■
button to select the lighting group
number.
Example:
Selecting one zone (zone number
displayed).
Selecting all zones (ALL means that all
lighting groups will be managed at the
same time).
Once the lighting group is selected,
■
press to access the command for
the lights.
Press or to set the lights command.
■
ON/OFF
ON: Lights ON.
OFF: Lights OFF.
When the lighting is set, press
■
to the next screen or wait 10 seconds to
go back to the default screen.
Note: If your installation uses gradual
lighting, UP and DOWN commands can be
used to increase and decrease your indoor
lighting (see DIMMING).

Lighting Control

repeatedly
or the Down
Lighting group
No. 8 controlled
All lighting groups
controlled
to go
DIMMING
UP: Lights dimming up.
STOP: Lights control stopped.
DOWN: Lights dimming down.
STOP: Lights control stopped.
When the lighting is set, press
■
to go to the next screen or wait
10 seconds to go back to the default
screen.
5