Carrier WTC-RCI-D Installationsanweisungen Seite 4

To optimise energy efficiency of the
building while preserving its occupants
comfort, the controller is scheduled
according to occupancy hours.
You can set the room occupancy
manually if the scheduled program does
not match the current occupancy status
of the room.
Occupied
For cassette fan coils with motorised
louvers, it is possible to control the
direction of the air flow by adjusting the
louver position.
1 to 6 fixed positions.
Automatic: Louver position is set
automatically.
Position 1 in Heating mode:
The heated air is directed to the floor
level.
Position 6 in Cooling mode:
The cooled air is distributed near the
ceiling.
Swing: Louvers keep oscillating from
the top downwards for better air
distribution.
4
Occupancy
To set room occupancy
■
■
■
Unoccupied
Louver Position
To set the position of louvers
■
Example:
Louver position: 1
■
■
Note: Louver position can be adjusted only
when the status of the room is occupied.
Press the Menu button
until the Occupancy screen appears.
Press the Up button
button to set the room occupancy to
ON or OFF.
When the room occupancy is set, press
to go to the next screen or wait 10
seconds to go back to the default
screen.
Press the Menu button
until the Louver screen appears.
Press the Up button
button to set the position of louvers.
Automatic
Fixed position (P1 to P6)
X
x = position number
Swing
When the louver position is set, press
to go to the next screen or wait
10 seconds to go back to the default screen.
repeatedly
or the Down
repeatedly
Louver position:
Swing
or the Down