Removal From Operation, Storage, Disposal; Removal From Operation; Storage; Disposal - Mettler Toledo InPro 7100-VP-Serie Bedienungsanleitung

18
5

Removal from operation, storage, disposal

5.1

Removal from operation

The sensor is only conditionally subject to aging. When used as intended
and appropriately maintained and serviced, the lifetime of the sensor can
extend to several years.
Before removing the sensor from the process/process adapter, it must be
ensured that the process pressure has been reduced to a safe level and the
process temperature lowered to a safe range. Any escape of hot process
medium under pressure can cause damage to material/equipment or
injury to persons.
After removal from the process, the sensor should first be flushed with
distilled water.
If the sensor incurs a defect, it can not be repaired and must be disposed
under observance of prevailing local regulations.
5.2

Storage

If the sensor is not in use, it can be stored dry. However, it has to be re-
conditioned accordingly prior to renewed operation. This procedure may
take several hours to complete.
5.3

Disposal

Disposal is to be carried out by the user in accordance with valid local
regulations.
The packaging consists of:
– cardboard
– plastic film
The sensor is composed of:
– medium-wetted materials according to the specifications of the sensor
– electronics material (cable, components)
– PEEK (plug)
InPro 7100-VP Series
52 002 092
© 10 /12 Mettler-Toledo AG, CH - 8606 Greifensee
InPro 7100-VP Series
Printed in USA