Removal From Operation, Storage, Disposal; Removal From Operation; Storage; Disposal - Mettler Toledo InPro 7108-VP/ CPVC Bedienungsanleitung

16
5

Removal from operation, storage, disposal

5.1

Removal from operation

The sensor is only conditionally subject to aging. When used as intended
and appropriately maintained and serviced, the lifetime of the sensor can
extend to several years.
Before removing the sensor from the process/process adapter, it must be
ensured that the process pressure has been reduced to a safe level and
the process temperature has lowered to a safe range. Any escape of hot
process medium under pressure can cause damage to material/equipment
or injury to persons.
After removal from the process the sensor should first be flushed with
distilled water.
If the sensor incurs a defect, it can not be repaired and must be disposed
under observance of prevailing local regulations.
5.2

Storage

If the sensor is not use, it can be stored dry. However, it has to be recon-
ditioned in the process fluid accordingly prior to renewed operat ion. This
procedure may take several hours to complete.
5.3

Disposal

The user is responsible for the proper disposal of the conductivity sensor. The
sensor contains electronic components that must be disposed of correctly
in order to avoid hazards to people or to the environment.
InPro 7100-VP Series
52 002 092
© 02 / 2017 Mettler-Toledo GmbH, CH - 8606 Greifensee
InPro 7100-VP Series
Printed in USA