Setting The Coff Ee Temperature - Atag CM 4111 AC Bedienungsanleitung

YOUR COFFEE MACHINE
1. Remove the "Total Hardness Test" strip (in front of your manual).
Th en dip it fully in the water for a few seconds. Remove it and
wait around 30 seconds until it changes colour and a number of
red dots are formed. For example, if there are 3 red squares on the
test strip, you must set the water hardness level to 3.
If you no longer have a water hardness test, you can fi nd the data
in the table below.
2. Press the MENU button
until the menu option WATER HARDNESS appears. Confi rm
the menu option with the OK button.
3. Th e display shows the current setting. Next press the scrolling
buttons < or > until the established hardness level is displayed.
Confi rm the selection with the OK button. Th e appliance is now
programmed to provide the descaling warning when necessary,
based on the actual hardness of the water.
Information on the hardness of the water in your area can be obtained
from the local water board. In the table below you can fi nd the water
hardness setting your machine requires.
German hardness
0 - 6 dH
7 - 13 dH
14 - 20 dH
> 21 dH

6.2.3 Setting the coff ee temperature

You can choose between three temperature levels. Th e coff ee
temperature levels are defi ned as follows:
• TEMPERATURE LOW
• TEMPERATURE MEDIUM
• TEMPERATURE HIGH
GB 25
6 Maintenance
and press the scrolling buttons < or >
French hardness
0 - 11 fH
12 - 17 fH
18 - 36 fH
> 37 fH
Water hardness
machine
1
2
3
4