Turning The Concentrator Off - AirSep VisionAire 2 Gebrauchsanweisung

EN
Optimal oxygen concentration is obtained within 10 minutes after
the device is switched on (90% of the concentration is obtained
after approximately 5 minutes).
It is very important to follow the prescribed level of oxygen flow.
Do not increase or decrease the flow until you first consult your
physician.
Normally, you should not need to adjust the flowmeter on your unit. If you turn
the flowmeter adjustment knob clockwise, you will decrease and can shut off the
flow of oxygen from your unit.
If oxygen does not seem to flow, first verify that the flowmeter
ball is registering a flow. Then, place the tip of the cannula into
a glass of water; if bubbles come out of the cannula, oxygen is
flowing. If bubbles do not appear, refer to Section 5.0.
Troubleshooting.
Ensure concentrator is operated in an upright position.
3.4

Turning the Concentrator Off

•
Set the I/0 power switch to the "0" position to turn off the unit.
EN-16
VisionAire™ 2 and VisionAire™ 3
®
AirSep Corporation
MN157-1 rev. B