Herunterladen Inhalt Inhalt Diese Seite drucken

AirSep VisionAire 2 Gebrauchsanweisung Seite 127

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 35
VisionAire™ 2 and VisionAire™ 3
Carefully review and familiarize yourself with the following important safety
information about the VisionAire™ 2 and VisionAire™ 3 Oxygen Concentrator.
®
AirSep
Corporation
MN157-1 rev. B
This device supplies high-concentration oxygen that promotes
rapid burning. Do not allow smoking or open flames within the
same room of (1) this device, or (2) any oxygen-carrying
accessory. Failure to observe this warning can result in severe
fire, property damage and / or cause physical injury or death.
This unit is not to be used for life-support. Geriatric, pediatric,
or any other patient unable to communicate discomfort while
using this oxygen concentrator may require additional
monitoring. Patients with hearing and/or sight impairments may
need assistance with monitoring the alarms.
If you feel discomfort or are experiencing a medical
emergency, seek medical assistance immediately.
Use no oil, grease, or petroleum-based or other flammable
products on or near nasal end of cannula or the unit. Oxygen
accelerates the combustion of flammable substances.
Electrical shock hazard. Disconnect the power cord from the
electric outlet before you clean the unit to prevent accidental
electrical shock and burn hazard. Only your Equipment
Provider or a qualified service technician should remove the
covers or service the unit.
Do not leave a nasal cannula under bed coverings or chair
cushions. If the unit is turned on but not in use, the oxygen will
make the material flammable. Set the I/0 power switch to the 0
(off) position when the unit is not in use.
Do not use extension cords with this unit or connect too many
plugs into the same electrical outlet. This can result in an
overload to the electrical panel causing the breaker/fuse to
activate.
Use only voltage specified on back panel label.
EN
EN-1

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Visionaire 3

Inhaltsverzeichnis