Humidifier Bottle Connection; Cannula Connection - AirSep VisionAire 2 Gebrauchsanweisung

EN
3.0 How To Operate Your Oxygen Concentrator
Review the following information before you operate your oxygen concentrator.
The concentrator releases warm air out the bottom of the unit
which can permanently discolor temperature sensitive flooring
surfaces such as vinyl. The concentrator should not be used over
flooring that is sensitive to heat staining. AirSep is not responsible
for flooring that becomes discolored.
3.1

Humidifier Bottle Connection

(Optional)
If additional humidification is required with your oxygen therapy, perform the
following steps each time you fill or clean the humidifier, which may have been
initially set up for your use.
1. Remove the humidifier bottle from the humidifier bottle recess.
2. Open the humidifier bottle. If you have a pre-filled bottle, do not perform
this step. Proceed to step 5.
3. Fill the humidifier bottle with cool or cold water (distilled water is
preferred) to the fill line indicated on the bottle. DO NOT OVERFILL.
4. Re-connect the top cover to the humidifier bottle.
5. Place the humidifier bottle in the humidifier bottle recess on the back of
the concentrator and connect the humidifier bottle tubing to the oxygen
outlet and the humidifier bottle fitting.
If the humidifier bottle tubing is not properly connected to the
humidifier bottle fitting or to the oxygen outlet, an oxygen leak
can occur.
3.2

Cannula Connection

Connect the tubing and cannula to the unit's oxygen outlet, or to the optional
humidifier's oxygen outlet.
EN-14
VisionAire™ 2 and VisionAire™ 3
®
AirSep Corporation
MN157-1 rev. B