AirSep VisionAire 2 Gebrauchsanweisung Seite 130

EN
EN-4
If the humidifier bottle tubing is not properly connected to the
humidifier bottle fitting or to the oxygen outlet, an oxygen leak
can occur.
Storing the device outside of its temperature specifications may
affect performance (refer to the specification section of the
manual).
Do not position the unit so that it is difficult to access the power
cord.
The concentrator should be located as to avoid pollutants or
fumes.
If oxygen does not seem to flow, first verify that the flowmeter
ball is registering a flow. Then, place the tip of the cannula into
a glass of water; if bubbles come out of the cannula, oxygen is
flowing. If bubbles do not appear, refer to Section 5.0.
Troubleshooting.
To prevent a voided AirSep warranty, follow all manufacturers'
instructions.
Replace the disposable cannula periodically following normal
usage according to your Equipment Providers
recommendations.
AirSep does not recommend the sterilization of this equipment.
VisionAire™ 2 and VisionAire™ 3
®
AirSep Corporation
MN157-1 rev. B