Instructions For Use - Silvercrest SHDM 650 A1 Bedienungsanleitung

INSTRUCTIONS FOR USE

Warning!
The hot dog grill (a) becomes very hot. To avoid burns, allow the grill
to completely cool down before removing it.
Warning!
Do not use too thin/crumbled bread.
Warning!
Do not try to insert too thick food with force.
Warning!
Just insert wurst/bread. Do not insert food that may drip during cook-
ing as it may make cleaning procedures difficult and may cause fire
hazard. add sauces and/or condiments only at the eND of the cooking
process, after having removed the food from the appliance.
- Cut two bread rolls in half, slightly press them and put them together to easily insert them
into the apposite slots (B).
- Position two wursts into the grill (A) and insert them into the container (C).
- Plug the appliance in and turn the setting dial (E) to select the required toasting level.
Warning!
In case of thin bread, position the setting dial on a lower level.
- Lower the on lever (D) until it locks.
Warning: the lever does not lock when the appliance is unplugged.
- Wait some minutes and, after the automatic ejection of the bread and the wurst from the
grill (A), check their cooking level; if they are not toasted/grilled enough, select a higher
toasting level and/or repeat the cooking procedure.
WarNING!
TemPeraTUre CaN Be aFFeCTeD BY SeVeraL VarIaBILITIeS.
- The final result can be affected by room temperature (cold rooms could reduce the power
of cooking, hot temperature can increase it).
- Pay attention on food temperature: always use food at room temperature (both wurst and
bread), keeping them away from fridge at least 1 hour before use.
- The final result can be affected by different sizes of food (size of wurst and bread).
- After the first use, the appliance can reach higher temperature during following uses since
it is already hot.
- Press the button (F) at any time to interrupt the toasting process.
Warning!
Do not remove bread and wurst with hands as they are hot and may burn.
Warning!
In case of repeated use, wait at least one minute to allow cooling between
a cycle and the other.
GB
IT
GB 5