The Control Panel - ecofort ecodry925 Handbuch

How to empty the tank
Open the front door and take out the tank as shown on Pic.2 . Use the
open (L) on the top of the tank to flow the water out. Finally put the
tank back into his place and close the front door.
Continuous drainage
The tank is ready to fit the continuous drainage: the installation is very
simple and then you will not need to empty the tank manually anymore.
To install the continuous drainage follow these instructions (Pic.3):
• remove the rubber stopper (T);
• connect a rubber hose with an internal diameter of 10 millimeters
to the connenctor on the tank and run it through the hole F on the
bottom of the dehumidifier;
• put the tank back into his place and close the door.
!
ATTENTION: to guarantee regular drainage of the water,
make sure that the drainpipe has a slope and is straight,
without any bends or constrictions. On any case the float-
ing device inside the tank is active and will stop the deu-
midifier when full.
Pic.3 – The continuous drainage
The air filter
The air is placed behind the front grid and can be easily removed for
cleaning. The air filter can be cleaned with a vacuum cleaner or with
water: in this case dry it before assembly.
S
Do not run the dehumidifier without the air filter to avoid
accumulating dust on the heat exchanger. Keep clean the
air filter in particular when al lot of dust is present in the
air: a dirty air filter reduces the air flow and the efficiency
of the dehumidifier.
How to remove the air filter
Pull the front grid upward: the air filter is behind the grid.
How to put the air filter on
Apply the air filter to the back side of the front grid and insert the wings
(B) into the holes (F) (Pic.5): then fix the grid to the bracket (S).

The control panel

S1 - Green light ON The green light indicates when the dehumidifier is
operative, otherwise it blinks on status 0.
S2 - Red light, full tank The light blinks, together with the green one
S1, when the tank is full, missing or incorrectly positioned.
S3 - Yellow light, defrost The light switches on during the automatic
defrosting cycle.
T1 - Decrease button Pushing this button the value of the display D
will decrease down to 0 value.
T2 - Increase button Pushing this button the value of the display D will
increase up to C value.
D - Display The display shows the working state of the dehumidifier
according with Tab.A. The value 0 means OFF, from 1 to 9 means auto-
matic functioning and it depends from the humidistat that switches on
or off the dehumidifier if the value of the relative humidity is higher or
lower of the one shown in the Tab.A. The value C means ALWAYS ON
and the dehumidifier works independently from the humidity value:
nevertheless any allarm has the priority on functioning mode.
ENGLISH
Page 9 of 20
Pic.4 – The air filter
Pic.5 – The air filter assembly
Pic.6 – The control panel
9