Warehousing - Eisemann BSKA 14 EV RSS cube Betriebsanleitung

• Comply with the regulations for storage of fuels.
• Protect the power generator from access by unauthorised persons and children.
• When putting the power generator back into operation, perform the daily checks before starting it.
8.1.

Warehousing

Warehousing is defined as the storage of the power generator in a not-operational state without time
limit. For this purpose, preservation work and checks at regular intervals are required. Storage
in weather-protected conditions is described below. For warehousing under different conditions,
please contact our service representatives.
• Perform all necessary maintenance and cleaning operations as described in the
<Maintenance> chapter.
• Empty the fuel tank completely.
• Perform an oil change.
• Remove the spark plug.
• Pour 10 cm³ of engine oil through the opening into each of the cylinders.
• Use the hand starter to slowly cycle the engine several times.
• Screw the spark plug back in.
• Close the suction inlet of the air filter and the exhaust outlet and make them air-tight.
• Remove the battery.
• Store the battery according to the instructions and check the level of charge every 2 months.
Recharge it as necessary.
• Preserve all surfaces with preserving agents.
• Protect the power generator against dust and moisture.
• Comply with the maximum storage temperature as shown on the rating plate.
• Protect the power generator against access by unauthorised persons and children.
• When removing the generator from storage, comply with the instructions for initial start-up and
perform the daily checks before staring up.
Page 37