Shooting A 3-D Object - Elmo L-1ex Bedienungsanleitung

Shooting a 3-D object

By adjusting the angle of the camera column and the camera head, a 3-D object can be shot
from the side.
n Setting the main unit
Connect the main unit to a projector or a PC monitor, and then turn on the power for the
main unit. Adjust the angle of the camera column and the camera head as shown in the
above figure to shoot the 3-D object.
n Adjusting the size
Adjust the zoom dial on the main unit or the zoom buttons [
control so that the part of the object you want to shoot fits the screen size.
n Adjusting the focus
Press the [AF] button on the main unit or on the remote control to focus the camera on the
object. In cases where the object cannot be brought into focus, select [Focus] from the
OSD and use [Manual] to focus.
N o t e
• The focus can be achieved from 50mm -
n Adjusting the brightness
Press the [BRIGHTNESS
the image brightness.
n Turning the illumination lamp ON/OFF
Move the illumination lamp switch on the main unit to the left/right to turn it ON/OFF.
Adjust
P.118
.
] and [BRIGHTNESS
P.121
English
Adjust
Adjust
/ ] on the remote
] buttons on the main unit to adjust
115