Elmo L-1ex Bedienungsanleitung Seite 107

n Saving the image
(1) Press the [ ] button on the operating panel or the [
switch the output image to the camera image.
(2) Make sure that the OSD is not displayed, and then press the [
operating panel or on the remote control.
(3) Saving begins when the [
when the symbol disappears.
N o t e
• Zoomed images cannot be saved during digital zooming. However, images which are
zoomed to the maximum [ZOOM-IN
be saved.
• Image data cannot be recorded with the correct date and time.
• Be sure to try shooting and confirm that the images are saved correctly beforehand.
If images cannot be saved normally due to some problem with this camera or the SD
card, ELMO is not liable to compensate for such failure.
] mark is only displayed on the screen when [Function Setting] → [Guide] is
• The [
set to ON from the Camera OSD menu.
• When the SD card is write-protected, images cannot be saved in the SD card.
• If the SD card is full when recording, an [X] mark is displayed on the screen. Delete
any unnecessary images or use another SD card.
• Never remove the SD card while it is reading or writing data. This may cause
malfunctions to occur.
• Do not turn off the power to this product while reading or writing to an SD card. This
may cause malfunctions to occur.
n Displaying the image
There are two display modes for SD images. You can use Single display to display one
image only, or 4 x 4 display to display 16 images.
Single display

(1) Make sure that the OSD is not displayed, and then press the [
operating panel or on the remote control. The output image changes to SD mode, and the
images stored on the SD card are displayed as single images.
(2) Make sure that the OSD is not displayed, and then press the [
operating panel or the [ ] button on the remote control to change to the next image.
Press the [ ] button on the operating panel or the [ ] button on the remote control
to return to the previous image.
(3) You can zoom in or out of the image being displayed by using the zoom dial on the
main unit, and you can reset zoom in/out by using the AF button on the main unit.
N o t e
• When an SD image is enlarged, the Scroll function cannot be used. If you want to use
the Scroll function, press the AF button to reset the image enlargement, and then scroll.
English
] mark is displayed on the screen. Saving is complete
] limit within the range of the optical zoom can
] button on the remote control to
] button on the
] button on the
] button on the
105