Presentation Using An Sd Card (Commercially-Available) - Elmo L-1ex Bedienungsanleitung

Presentation using an SD card
(commercially-available)
N o t e
• Before starting, insert a commercially available SD card into the SD card slot on the
side panel. Push the card again to remove the SD card.
• Insert the SD card with the label facing up. Forcing it into the slot in the wrong
orientation may cause a malfunction.
• Before loading or unloading the SD card or turning the power off, be sure to select
the camera image by pressing the camera button [
confirm that the output image has been switched to camera image. Otherwise, the SD
card contents could be damaged or the camera could malfunction.
• The SD card is composed of parts vulnerable to static electricity. Therefore, due to
static electricity, the SD card could malfunction or its contents could be destroyed.
When handling the SD card, take care to avoid static electricity.
• You may not be able to display image data other than that saved in this product or
converted using the conversion function of the software supplied. Also, images of
7MBs or more cannot be displayed.
• When displaying image data in an unsupported format, [
the output screen.
• If you try displaying image data on an SD card without inserting an SD card, a black
screen with the message [
• After using the SD card, do not leave it inserted in this product; be sure to remove it.
• W e r e c o m m e n d u s i n g S D c a r d s ( 5 1 2 M B , 1 G B , a n d 2 G B ) m a d e b y
Panasonic, and SDHC cards (up to 4GB) made by Panasonic.
T h e re s o l u t i o n f o r t h e s t o re d i m a g e s i s 1 2 8 0 x 1 0 2 4 ( f o r S X G A o u t p u t ) ,
1280x800 (for WXGA output), and 1280x960 (for XGA output).
This product can store up to 2048 images.
• ELMO is not liable for any damage caused by the loss of the data in the SD card or
passive damage.
• When an SD card is inserted, "Card Reading" is displayed on the screen, and
to allow this device to check the contents of the SD card, it may take some time
between inserting the card and the JPEGs being displayed and captured.
In that case, please wait a short time before performing any of the operations
mentioned above.
• When an SD card is inserted and then the power to the main unit is turned on, it may
take a while before operations can be performed on the main unit.
• Please wait a short time until the power switch on the main unit lights blue before
performing any operations.
104
English
] is displayed.
] on the operating panel, and
] or [ ] is displayed on