Mask Function; Mask Settings; Mask Operations - Elmo L-1ex Bedienungsanleitung

Mask Function

You can mask a section of the output image.
■

Mask settings

From the Camera Mode OSD Menu select [Function Setting] → [Mask]. When [Darkness]
is selected the level bar is displayed, and you can then set the darkness for the areas
outside the highlighted section with the [
■

Mask operations

When you press the [
Image or SD Mode, the mask display uses the darkness set previously.
You can move the masked area using the [ ], [ ], [ ]. and [ ] buttons on the remote
control.
The mask display is cleared when you press the [
N o t e
• The mask function cannot be used when the output image is PC.
• In the optical zoom range, the mask size remains the same. In the digital zoom range,
the mask size expands and contracts depending on the magnification ratio.
• Cannot mask the entire output image.
128
English
] and [
] button on the remote control while the output image is Camera
] buttons.
] button on the remote control again.