Factory Presets - Yamaha RX-N600 Bedienungsanleitung

ADVANCED SETUP
Speaker impedance
Use this feature to set the speaker impedance of this unit
so that it matches that of your speakers.
Choices: 8ΩMIN, 6ΩMIN
• Select "8ΩMIN" to set the speaker impedance to 8 Ω .
• Select "6ΩMIN" to set the speaker impedance to 6 Ω .
SP IMP. Speaker
Front
8ΩMIN
Center
Surround
Surround back
Front
6ΩMIN
Center
Surround
Surround back
*
The Canada model cannot use two separate speaker systems
(A and B) simultaneously when "SP IMP." is set to "8ΩMIN".
82
En
SP IMP.
Impedance level
If you use one set (A or B),
the impedance of each
speaker must be 8 Ω or
higher.
If you use two sets (A and
B), the impedance of each
speaker must be 16 Ω or
*
higher.
The impedance of each
speaker must be 8 Ω or
higher.
If you use one set (A or B),
the impedance of each
speaker must be 4 Ω or
higher.
If you use two sets (A and
B), the impedance of each
speaker must be 8 Ω or
higher.
The impedance of each
speaker must be 6 Ω or
higher.

Factory presets

Use this feature to reset all the parameters of this unit to
the initial factory settings (see page 99).
Choices: CANCEL, RESET
• Select "CANCEL" not to reset any parameters of this
unit.
• Select "RESET" to reset the parameters of this unit.
Notes
• This setting completely resets all the parameters of this unit
including the "SET MENU" parameters. However, the
advanced setup menu parameters will not be initialized.
• The initial factory settings are activated next time you turn on
this unit.
Network reset
Use this feature to reset the network settings of this unit
(see page 76) to the initial factory settings.
Choices: CANCEL, RESET
• Select "CANCEL" not to reset any network settings of
this unit.
• Select "RESET" to reset the network settings of this
unit.
Notes
• The initial factory settings are activated next time you turn on
this unit.
• When the network settings are reset, "DHCP" in "NET/USB
MENU" is automatically set to "ON" (see page 76) and the
registered client ID of this unit on your YAMAHA MCX-2000
is cleared (see page 96).
Remote control AMP ID
Use this feature to set the AMP ID of this unit for remote
control recognition (see page 87).
Choices: ID1, ID2
• Select "ID1" when the remote control AMP ID library
code is set to "00001".
• Select "ID2" when the remote control AMP ID library
code is set to "00002".
Note
You need to set the corresponding remote control AMP library
code for the remote control (see page 87).
PRESET
N-RESET
REMOTE AMP