Selecting The Input Mode; Using The Sleep Timer - Yamaha RX-N600 Bedienungsanleitung

y
"NIGHT:CINEMA" and "NIGHT:MUSIC" adjustments are
stored independently.
Notes
• You cannot use the night listening modes in the following
cases:
– when the "DIRECT STEREO" mode (see page 39) is
selected.
– when the component connected to the MULTI CH
INPUT jacks is selected as the input source (see
page 38).
– when headphones are connected to the PHONES jack.
• The effectiveness of the night listening modes may vary
depending on the input source and surround sound settings
you use.

Selecting the input mode

This unit comes with a variety of input jacks. Do the
following to select the type of input signals you want to
use.
y
• We recommend setting "INPUT MODE" to "AUTO" in most
cases.
• You can adjust the default input mode of this unit by using the
"INPUT MODE" parameter in "INPUT MENU" (see page 75).
Notes
• To play DTS-encoded CDs when using a digital audio
connection, be sure to set "INPUT MODE" to "DTS".
• DTS decoding may not be performed correctly depending on
the player even if you make a digital connection between this
unit and the player.
1
Rotate the INPUT selector on the front panel
to select the desired input source.
INPUT
2
Press INPUT MODE on the front panel
repeatedly to select the desired input mode.
INPUT MODE
Available input sources
NET DVR V-AUX
USB
SP
A
DVD
Currently selected
input source
pDVD
DTV/CBL MD/CD-R TUNER CD
VOLUME
dB
AUTO
L R
Currently selected
input mode
AUTO
Automatically selects input signals in
the following order:
(1) Digital signals
(2) Analog signals
DTS
Selects only digital signals encoded in
DTS. If no DTS signals are input, no
sound is output.
ANALOG
Selects only analog signals. If no
analog signals are input, no sound is
output.
Note
When "INPUT MODE" is set to "AUTO", this unit
automatically switches to the appropriate decoder if a Dolby
Digital or DTS signal is detected.

Using the sleep timer

Use this feature to automatically set this unit to the
standby mode after a certain amount of time. The sleep
timer is useful when you are going to sleep while this unit
is playing or recording a source. The sleep timer also
automatically turns off any external components
connected to AC OUTLET(S) (see page 26).
1
Press one of the input selector buttons on
the remote control to select the desired input
source.
MD
CD CD-R
CBL
DVD DTV
DOCK
V-AUX DVR
2
Start playback on the selected source
component or select a broadcast station.
• Refer to the operating instructions for the source
component.
• See page 46 for details about tuning instructions.
USING AUDIO FEATURES
SLEEP
MULTI CH IN
TUNER
USB
NET
35
En