Transport And Storage; Disposal And Recycling; Spare-Part Ordering - Scheppach FS 3600 Originalanleitung

AC motor 230 V/ 50 Hz
Mains voltage 230 Volt / 50 Hz.
Mains connection and extension cable must have
3-wires = P + N + SL. - (1/N/PE).
Extension cables must have a minimum cross-sec-
tion of 1.5 mm².
The mains connection is secured with a max. 16A
fuse.
11. Maintenance
Cleaning
Caution! Pull out power plug.
• Clean the machine after each work cycle.
• Replace worn out cutting discs.
• Replace damaged protection device
• Dust and pollution must be removed regularly from
the machine. The best way to clean the machine is
with a piece of cloth or brush.
• Do not use any corrosive substances to clean the
plastic. A damp cloth is sufficient in most cases.
• The tub (4) and coolant pump (13) must be cleaned
regularly to remove dirt, as otherwise the pump or
the pipe or the cooling of the diamond cutting disc
(10) is not guaranteed.
Servicing
• All moveable parts must be re-lubricated at peri-
odic intervals.

12. Transport and Storage

Attention! Pull out the power plug
To transport the machine, position the machine head
to the front and use the adjustment stops to fix it in
place.
Store the equipment and accessories out of chil-
dren's reach in a dark and dry place at above freez-
ing temperature. The ideal storage temperature is
between 5 and 30 °C. Store the electric tool in its
original packaging. Cover the power tool to protect
it from dust or moisture. Keep the operating instruc-
tions with the power tool.

13. Disposal and recycling

The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types
of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.
Old devices must not be disposed of with
household waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical
and electronic equipment (WEEE). This product must
be disposed of at a designated collection point. This
can occur, for example, by handing it in at an autho-
rised collecting point for the recycling of waste elec-
trical and electronic equipment. Improper handling
of waste equipment may have negative consequen-
ces for the environment and human health due to
potentially hazardous substances that are often con-
tained in electrical and electronic equipment. By pro-
perly disposing of this product, you are also contri-
buting to the effective use of natural resources. You
can obtain information on collection points for waste
equipment from your municipal administration, pub-
lic waste disposal authority, an authorised body for
the disposal of waste electrical and electronic equip-
ment or your waste disposal company.

14. Spare-part ordering

Please quote the following in your order for spare
parts:
• Type of device
• Article No. of device
• Ident. No. of device
• Spare Part No. of the required spare part
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the
following parts are therefore also required for use as
consumables.
Wear parts*: Cutting wheel, carbon brush, table and
cutting head guides
* Not necessarily included in the scope of delivery!
GB 21