Bostitch BTCN560 Bersetzt Von Den Originalanweisungen Seite 47

TROUBLESHOOTING GUIDE (continued)
SYMPTOM CAUSE
Tool operates, No nails in magazine
but no fastener is
Wrong size or angle nails
driven
Debris in nosepiece
Debris in magazine
Worn magazine
Damaged or worn driver
blade
Damaged pusher spring
Jammed nail Wrong size or angle nails
Magazine screws not
secured after previous jam
clear/inspection
Damaged or worn driver
blade
Material and fastener length
Debris in nosepiece
Tool is not yet run-in
Use of incorrect speed
Worn magazine
Damaged pusher spring
Dry fire lock out is engaged
with only 7–9 nails
remaining in magazine
and the user is applying
excessive force to contact
trip, overriding the lockout
FIX
Load nails in magazine.
Use only the recommended nails. Refer to Technical Data.
Clean nose area and watch closely for small pieces of broken nails stuck in the
track
Clean magazine.
Replace magazine. See authorised Bostitch repair agent.
Replace driver blade. See authorised Bostitch repair agent.
Replace spring; See authorised Bostitch repair agent.
Use only the recommended nails. Refer to Technical Data.
Make sure to tighten magazine hex bolts with wrench provided.
Replace driver blade. See authorised Bostitch repair agent.
If the unit continues to stall (forcing the need to rotate the Stall release lever)
choose the appropriate material and fastener length that is not too rigorous
an application.
Clean nose area and watch closely for small pieces of broken nails stuck in
the track.
New tools can take 500–1000 nails for parts to mesh and wear in together.
Drive shorter nails during this period if experiencing difficulty driving nails flush.
If trying to drive longer ring shank nails in soft woods, or driving ring shank nails
into harder materials in speed 1–adjust speed setting to position 2.
Replace magazine. See authorised Bostitch repair agent.
Replace spring. See authorised Bostitch repair agent.
Load more nails in magazine to disengage dryfire lockout.
EnGLIsh
45