Bostitch BTCN560 Bersetzt Von Den Originalanweisungen Seite 45

TROUBLESHOOTING GUIDE
MANY COMMON PROBLEMS CAN BE SOLVED EASILY BY
UTILISING THE CHART BELOW.
For more serious or persistent problems, contact your nearest
authorised Bostitch repair agent, or contact your Bostitch office
at the address indicated in this manual.

WARNING: To reduce the risk of serious personal injury,
ALWAYS lock off the tool and disconnect battery pack
from tool before all repairs
SYMPTOM CAUSE
Motor does not Trigger lock in locked
run with trigger position
depressed
Tool is stalled, locking the
motor from rotating
Tool is in the sequential
actuation mode
Tool internal electronics
need to be reset
Motor stops running after 5
seconds
Terminals are dirty or
damaged
Damaged internal
electronics
Damaged trigger
Battery is hot
Tool is hot
Motor does not Trigger lock in locked
run with contact position
trip depressed
Dry fire lock out engaged,
blocking contact trip from
traveling fully
Tool is stalled, locking the
motor from rotating
Bent contact trip
Motor stops running after 5
seconds
Terminals are dirty or
damaged
Damaged internal
electronics
Damaged trigger
Battery is hot
Tool is hot
FIX
Unlock trigger lock.
Rotate the stall release lever on the tool and the mechanism will release. If
driver blade does not return, remove battery and manually push driver blade
back to home position.
Depress contact trip first before firing or switch to bump mode (BTCN560 only).
Remove battery, wait 3 seconds and reinsert.
Normal operation, release trigger and redepress.
See authorised Bostitch repair agent.
See authorised Bostitch repair agent.
See authorised Bostitch repair agent.
Let the battery cool or replace it with a cool pack.
Let the tool cool down before continuing use.
Unlock trigger lock.
Load more nails into magazine.
Rotate the stall release lever on the tool and the mechanism will release. If
driver blade does not return, remove battery and manually push driver blade
back to home position.
See authorised Bostitch repair agent.
Normal operation, release contact trip and redepress.
See authorised Bostitch repair agent.
See authorised Bostitch repair agent.
See authorised Bostitch repair agent.
Let the battery cool or replace it with a cool pack.
Let the tool cool down before continuing use.
EnGLIsh
43