Intended Use - Bostitch BTCN560 Bersetzt Von Den Originalanweisungen

Wear ear protection.
Wear eye protection.
Do not apply lubrication to tool.
Discard the battery pack with due care for
the environment
Suitable nail collation angle.
Length of nails
Nail thickness
Nail capacity
Date Code Position
The date code, which also includes the year of manufacture, is
printed into the underside of the housing.
Example:
2017 XX XX
Year of Manufacture
Description (Fig. A)

WARNING: Never modify the power tool or any part of it.
Damage or personal injury could result.
Trigger
1
Trigger safety lock-off
2
Contact trip
3
Depth adjustment wheel
4
Low battery and jam/stall indicator light
5
Stall release lever
6
Magazine
7
Pusher latch
8
Mode selector switch
9
Rotating rafter/belt hook
10
On-board hex wrench
11
Battery pack
12
Non-mar tip
13
Dual speed selection switch
14

Intended Use

The BTCN560 and BTCN565 cordless framing nailers have been
designed for driving nails into wooden workpieces.
The BTCN560 cordless framing nailer is designed for sequential/
bump modes. Nailers designed for sequential/bump modes
MUsT nOT be used on scaffoldings, stairs, ladders or ladder-like
constructions, e.g., roof laths. For exemptions check your local
national workplace regulations.
The BTCN565 cordless framing nailer is designed for sequential
and RapidCycle mode. Nailers designed for sequential and
RapidCycle mode MaY BE used on scaffoldings, stairs, ladders
or ladder-like constructions, e.g., roof laths.
DO nOT use under wet conditions or in the presence of
flammable liquids or gases.
These cordless nailers are professional power tools.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
Young children and the infirm. This appliance is not
•
intended for use by young children or infirm persons
without supervision.
• This product is not intended for use by persons (including
children) suffering from diminished physical, sensory or
mental abilities; lack of experience, knowledge or skills
unless they are supervised by a person responsible for their
safety. Children should never be left alone with this product.
ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect battery pack
before making any adjustments or removing/
installing attachments or accessories. An accidental
start-up can cause injury.

WARNING: Use only Bostitch battery packs and chargers.
Inserting and Removing the Battery Pack
from the Tool (Fig. B)
nOTE: Make sure your battery pack
To Install the Battery Pack into the Tool
Handle
1. Align the battery pack
12
handle (Fig. B).
2. Slide it into the handle until the battery pack is firmly seated
in the tool and ensure that you hear the lock snap into place.
To Remove the Battery Pack from the Tool
1. Press the release button
out of the tool handle.
2. Insert battery pack into the charger as described in the
charger section of this manual.
Fuel Gauge Battery Packs (Fig. B)
Some Bostitch battery packs include a fuel gauge which consists
of three green LED lights that indicate the level of charge
remaining in the battery pack.
To actuate the fuel gauge, press and hold the fuel gauge
button 15 . A combination of the three green LED lights will
illuminate designating the level of charge left. When the level
of charge in the battery is below the usable limit, the fuel gauge
will not illuminate and the battery will need to be recharged.
nOTE: The fuel gauge is only an indication of the charge left on
the battery pack. It does not indicate tool functionality and is
EnGLIsh
is fully charged.
12
with the rails inside the tool's
and firmly pull the battery pack
18
39