Cutting Operation; Stop Cutting Operation; Changing The Blade; Maintenance - GÖLZ FS175 Bedienungsanleitung

FS175
Completely raise the machine until the brake engages
(blade may have no ground contact). Engine switch is
in ON position (1).
Emergency switch is unlock (2).Start the engine as
described in the engines manual (3).
4.3

Cutting operation

Danger: Operating with too high feed
the machine might rise out of cut! In
emergency situations cut off the
engine as described in the engines
manual!
2
Connect the water supply and slowly lower the
machine with the hand wheel (1) till the blade has
ground contact. Putting down the machine to the
desired cutting depth which is displaying on the cutting
depth indicator (2).
Before you lower the machine by means of the hand
wheel (1), the mini ball valve is to be opened. Lower
the machine to such extent that you reach the desired
cutting depth (2).
Pull then the indexing plunger (3) on the control panel,
so that it snaps into the catch disk in order to fix the
desired cutting depth.
Work with even feed pressure. Too high feed pressure
leads to overload of the engine, there is a risk that the
machine raises. Too low feed pressure polishes the
segments and they become blunt.
Attention: In order to avoid damage
to the machine and the cutting disc,
please observe the maximum cutting
depth!
Note: Do not lower the cutting disc
forcibly, this could lead to damage to
the cutting disc and to the machine.
4.4

Stop cutting operation

After cutting completely raise the machine and cut off
the engine by ON-OFF switch (1) or Emergency switch
(2) as described in the engines manual.
4.5
1 3
The blade must be changed if:
•
•
•
•
For fitting a new blade, proceed as described in the
chapter "Mounting the blade".
5.
5.1
For maintenance jobs the machine has to be shut
down. For maintenance jobs which must be done while
the machine is running, the blade has to be
dismounted before beginning the job.
In accordance to the given cycles, the subsequently
described maintenance work has to be enforced. Also
the wearing part subject to no certain maintenance-
intervals has to be checked regularly for wear and to
adjust if necessary or to exchange. With I.C. engines,
the maintenance work has to be enforced in
accordance with the separate maintenance-instruction
of the engine manufacturer.
- 32-
1
Danger: Some
combustion engine become very hot
during operation, risk of burns!

Changing the blade

the diamond segments of the blade are
completely worn
the material to be cut changes
the blade turns irregularly
the diamond segments are damaged or broken

Maintenance

General

Information: Unconditional
the owner's manual of the engine
manufacturer, which is added!
Information: Clean the machine after
every operation.
environmental regulations!
Attention: When handling oil, grease
and other chemical
observe the product-related safety
regulations!
®
2
parts of the
observe
Observe local
substances,
5007287-01
BA-DE-GB-FR-NL