2.13 Store; Preparing For Operation; Export Checking; Installation - GÖLZ FS175 Bedienungsanleitung

FS175
Attention: Check that all parts of the
machine are
transporting. Before transporting the
blade must be removed!
For loading, only use lifting gear and
tackle of sufficient capacity. Lift the
machine using the lifting eye.
During cuts displace the machine
only with non-rotating blade (not
running engine)!
Injury hazard: Down coming
parts!

2.13 Store

Store the machine in a dry, high or locked place, out of
the reach of children or unauthorized persons. Clean
and preserve the machine with corrosion preventive if
storing over a longer time like winter time!
Note: Store dismounted blades so, that the blades not
exposed to mechanical
environmental conditions (UV radiation, temperature,
humidity, etc.).
Attention: Store blades just standing
or hanging!
3.

Preparing for Operation

3.1

Export checking

Remove the transport packaging and dispose of it in
an environmentally responsible way. Check the
machine for completeness and intactness. For the
scope of delivery, see "Scope of delivery and provided
accessory".
Secure the machine against accidental start-up and
rolling away.
Attention: Read and observe all opera-
ting instructions which are relevant for
the machine (floor saw, engine ...)!
The machine is supplied with engine oil but without
fuel.
Attention: Before starting up, check
the engine oil level and fill up the fuel!
well fastened before
damages and harmful
3.2

Installation

Place the machine on an even, firm and stable ground.
Have the working area well lightened. Keep the
working area clean, cluttered areas invite injuries.
Operating the machine on enclosed premises, make
sure that there is sufficient ventilation. Observe the
regulations in force at the respective site.
Note: If the oil level is too low, fill up
the engine according to the operating
manual of the engine manufacturer!
Fill up the fuel for the engine
according to the operating manual of
the engine manufacturer!
3.3

Blade

The cutting discs must meet the specification of
®
GÖLZ GmbH. Use the corresponding cutting discs
depending on the material to be processed, the
machining process and the type of work to be
performed! When not used properly, no liability is
assumed for damages resulting therefrom.
All used cutting discs must be designed, regarding
their maximum admissible cutting speed, for the max.
drive speed of the machine. For machines with
variable drive speed, use cutting discs which,
regarding their maximum admissible cutting speed,
correspond to the respective maximum drive speed of
the machine. Never use faulty or damaged blades.
Check the correct rotation of the blade to the spindle
shaft!
Check the blade is well fastened before beginning to
operate. Defective cutting discs must be replaced
immediately!
Cut off the engine or disconnect the power supply
before mounting or changing blade. After mounting, do
not leave any tools, such as open-end spanners, on
the machine.
Use only blades suitable to the blade acceptance
(arbor hole, flanges).
Danger: Faulty or damaged blades
can cause injuries to the operator and
other persons!
Information: Wrong rotation of the
blade will result in more wear of the
blade!
Danger: Wrong rotation of the blade
may result in segments cracking off
and can cause injuries to the operator
or other persons!
- 29-
®
5007287-01
BA-DE-GB-FR-NL