Intended Use; Operating Range; Organisational Measures - GÖLZ FS175 Bedienungsanleitung

FS175
Attention: Contains instructions which
must be strictly observed to prevent
damage from the unit and the operator!
Important text passages are highlighted in italics or
bold or can be found in a grey highlighted text field.
2.1

Intended use

The machine has been built in accordance with state-
of-the-art standards and the recognized safety rules.
Nevertheless, its use may constitute a risk to life and
limb of the user or of third parties, or cause damage to
the machine and to other material property.
The machine must only be used in technical perfect
condition in accordance with its designated use and
the instructions set out in the operating manual, and
only by safety-conscious persons who are fully aware
of the risks involved in operating the machine. Any
functional disorders, especially those affecting the
safety of the machine, should therefore be rectified
immediately!
The machine is designed exclusively for cutting in
concrete, reinforced concrete, natural stone, cast
stone and brickwork. Using the machine for purposes
other than mentioned above (such as cutting in wood
and so on) is considered contrary to its designated
®
use. The GÖLZ GmbH cannot be held liable for any
damage resulting from such use. The risk of such
misuse lies entirely with the user.
Only use gear drives and motors, which are provided
®
by GÖLZ GmbH. Also attend those operating
manuals.
Operating the machine within the limits of its
designated use also
instructions set out in the operating manual and
complying with the inspection and maintenance
directives.
Attention: Read and observe all the
operating instructions which belong
to this unit!
2.2

Operating range

Do not modify, add components to or retrofit the unit in
a way which could affect its safety and do not use non-
official accessories! This is not allowed without prior
®
approval of GÖLZ GmbH!
2.3

Organisational measures

This operating manual must always be at hand at the
place of use of the machine and must be accessible to
the person operating the machine!
involves observing
In addition to this operating manual, all other generally
applicable legal and other mandatory regulations
relevant to accident prevention and environmental
protection must be observed! Such obligations may
also comprise the handling of hazardous materials,
provisioning and/ or wearing of personal protective
equipment, or road traffic regulations.
This operating manual must be supplemented by
instructions covering the duties involved in supervising
and notifying special organizational features, such as
job organization, work flows or the person entrusted
with the work. Person entrusted with work on the
machine must have read the operating manual prior to
taking up work. This applies especially to persons
working only occasionally on the machine, e.g. during
set-up or maintenance activities.
Check - at least from time to time - whether the
personnel is carrying out the work in compliance with
the operating manual and paying attention to risks and
safety-relevant factors.
For reasons of safety, long hair must be tied back or
otherwise secured, garments must be close-fitting and
no jewellery - including rings - may be worn.
Severe injury may result from being caught by moving
parts of the machine. Personal protective equipment
must be used wherever required by the circumstances
or by law (e.g. safety glasses, ear protectors, safety
boots, suitable
regulations for prevention of accidents! Observe all
safety precautions and warnings attached to the
machine and always keep them in good and perfectly
legible condition.
The personal protection equipment should consist
of the following parts:
1) Hard hat with ear muff
the
2) Visor or safety glasses
3) Dust mask
4) Protective gloves
5) Safety clothes
6) Safety boots
In case event of safety-relevant modifications or
changes in the behaviour of the machine, stop the
machine immediately and report the malfunction to the
competent authority/ person. Do not remove or make
inoperative any safety devices the machine is
equipped with.
Never make
conversions which might affect safety without GÖLZ
- 25-
safety clothing). Observe
any modifications,
BA-DE-GB-FR-NL
®
the
additions or
®
5007287-01