Before Installation - LIVARNO LUX 113227-14-01 Montage-, Bedienungs- Und Sicherheitshinweise

Danger to life by
electric shock
Always check the light for
damage before connecting it
to the mains. Never use the
light if it shows any signs of
damage.
Prior to installation, verify that
the mains voltage on site corre-
sponds with the operating
voltage required for the light
(230 V∼ 50 Hz). Otherwise do
not install the light.
CAUTION! DANGER OF
BURN INJURIES! To pre-
vent burns, verify the light is
switched off and has cooled
down for at least 15 min be-
fore touching it. Lamps can
become very hot.
FIRE HAZARD!
Fit the light so that it
1.0 m
is at least 1.0 m
away from the material to be
illuminated. Excessive heat can
result in a fire.
CAUTION! RISK
OF INJURY! Bro-
ken lamp glass must
8 GB/IE
be replaced before any further
use is made of the lamp.
The spotlight is only suited for
use with the built-in LED control
gear.
The product continues to draw
a small amount of power even
if the lamp is off as long as
product is connected to supply
mains. To switch the device off
completely, the mains switch
should be switched off.

Before installation

Important: The electrical con-
nection must be established by a
qualified electrician or a person
trained to perform electrical instal-
lations. This person must be famil-
iar with the properties of the light
and the connection regulations.
Before installation ensure that
the circuit, to which the light
will be connected, is not ener-
gised. To do so, remove the fuse
or switch off the circuit breaker
in the fuse box (0 position).