Installation; Connecting The Lamp - LIVARNO LUX 113227-14-01 Montage-, Bedienungs- Und Sicherheitshinweise

Use the voltage tester to verify
the de-energised status.
The included mounting material
(screws and wall plugs
3
is suitable for ordinary solid con-
crete or masonry construction.
Check which mounting material
is suitable for your chosen mount-
ing surface. If necessary, seek
expert advice.
The included ground stake
is suitable for mounting in soil
(e.g. lawn or flower bed). The
soil must be soft enough to push
the ground stake in without
applying force (e.g. hammer
strike), but must be firm enough
at the same time to ensure the
lamp is securely fixed.

Installation

When selecting the mounting loca-
tion, pay attention to the following:
Make sure that the spotlight
illuminates the desired area.
You can move the spotlight
vertically.
Make sure the motion detector
covers the desired area.
9
The motion detector has a
maximum coverage range of
10 m, with a coverage angle
) of about 180° (depending on
1
the mounting height – a height
of 1.80–2.50 m is ideal).
Make sure the motion detector
is not illuminated at night by
street lighting. This can influence
its functioning.
10

Connecting the lamp

Open the connection box
by using a Phillips screw driver
to loosen the fixing screws
of the connection box (Fig. B).
Run the flexible supply line,
type H05RN-F 3G 1.0 mm
through the cable gland
and into the connection box.
The length for the flexible
supply line should not exceed
2.5 m. Open the terminal block
by using a cross-head screw
4 13
driver to loosen the fixing screws.
Fix the connection cable by
turning the nut of the cable
gland (Fig. C).
6
12
,
2
14
GB/IE 9