Attach ferrules to the wires of
the supply line. Also attach the
cord anchorage
supply line and use pliers to
tighten it on the supply line
(Fig. D). Connect them with the
terminal block
nection box. Pay attention to
the markings on the terminal
block (L for live, N for neutral
and
for the earth wire)
(Fig. E). Close the terminal block
again by fastening the fixing
screws.
Place the protection plastic
cover
on the terminal block
19
(Fig. F).
Close the connection box
again by fastening the fixing
screws (Fig. G).
Wall Mounting
Place the mounting bracket
on the wall and mark the fas-
tening holes for the mounting
bracket.
Now drill the fastening holes
(Ø 8 mm) and push the wall
plugs
into the drill holes.
1
10 GB/IE
to the
18
in the con-
13
5
Insert the included screws
into the washers
Fix the mounting bracket on the
wall using the screws provided.
Align the spotlight
desired direction. For this, you
may need to slacken the lock-
ing screws
of the hinge joint.
7
After alignment, tighten the
locking screws of the hinge
joint again, to ensure a secure
hold (Fig. J).
Mounting with
ground stake
Loosen the knurled screws
of the ground stake
secure the ground stake, using
the knurled screw, onto the
middle hole of the mounting
bracket
.
5
Insert the LED spotlight with the
ground stake far enough into
the ground so it is firmly seated.
Make sure it is firmly placed.
Do not use excessive force,
e.g. strike with a hammer. This
could damage the product.
3
(Ø 20 mm).
2
into the
4
11
and
10