Before Installation - LIVARNO LUX HG06726A Montage-, Bedienungs- Und Sicherheitshinweise

Danger to life
by electric shock
Always check the product for damage before connecting it to
the mains. Never use the product if it shows any signs of
damage.
Prior to installation, verify that the mains voltage on site corre-
sponds with the operating voltage required for the product
(230 V∼ 50 Hz). Otherwise do not install the product.
The product is only suited for use with the built-in LED control gear.
The LEDs are not replaceable.
If the LEDs fail at the end of their lives, the entire product must
be replaced.
The product continues to draw a small amount of power even
if the product is off as long as product is connected to supply
mains. To switch the device off completely, the mains switch
should be switched off.
Never use your product if you discover that it is damaged in
any way.
Do not use this product for dimmers or electronic switches. It is
not suitable for these purposes.

Before installation

Note: Remove all packaging materials from the product.
Important: The electrical connection must be established by a
qualified electrician or a person trained to perform electrical instal-
lations. This person must be familiar with the properties of the
product and the connection regulations.
Before installation ensure that the circuit, to which the product
will be connected, is not energised. To do so, remove the fuse
GB/IE 21